P4MM4 – read user manual online or download in PDF format. Pages in total: Biostar | P4MM4 | Owner’s Manual | Biostar P4MM4 Owner’s Manual The content of this user’s manual is subject to be changed without notice and we . P4MM4 VIA P4M gaming motherboard features-Socket ;Supports Intel Pentium 4/Celeron D/Celeron Processor;Supports FSB /MHz;Support.

Author: Migis Brale
Country: Mauritius
Language: English (Spanish)
Genre: Software
Published (Last): 17 July 2014
Pages: 308
PDF File Size: 11.10 Mb
ePub File Size: 4.1 Mb
ISBN: 985-6-77740-575-7
Downloads: 96811
Price: Free* [*Free Regsitration Required]
Uploader: Kajikasa

It also coordinates communications with the PCI bus. Pop up the following dialog.

Biostar P4MM4 | P4MM4 user’s manual – Page 17

This connector supports the provided floppy drive ribbon cables. Then system will do fail-safe reboot by using Watchdog function. Back up data and applications files. Load Optimized Defaults This selection allows you to reload the BIOS when the system is having problems particularly with the boot sequence. This action will boot-up the system according to FSB of the processor.

This PCI slot is designated as 32 bits. HDD Power Down When enabled, the hard disk drive will power down and after a set time of system inactivity. When you see the following dialog in setup procedure, it means setup is completed.


If the following message is shown after boot-up the system, it means the BIOS contents are corrupted. System will update BIOS automatically and restart.

Biostar P4M80-M4 Owner’s Manual

TM2 Bus Ratio This option represents the frequency bus ratio of the throttled performance state that will be initiated when the on-diesensor goes from not hot to hot. Overclock Panel contains the these features: Let user select a restoring way if system need to do a fail-safe reboot. Call the drive manufacturers for compatibility with other drives.

Hold the CPU down firmly, and then close the lever to complete the installation. If the testing is ok, then the current frequency will be saved into system registry. Clear manuap CMOS data. Biostae Graphics Port Slot Your monitor will attach directly to that video card. Main Panel contains features as follows: Item Options Date mm: Remove AC power line. Whenever the Tray Icon utility is launched, it will display a little tray icon on the right side of Windows Taskbar.

If the interface does not support prefetching.

With a user-friendly Status Animation, it can represent 3 overclock percentage stages: Make sure both ends are securely plugged in; check the drive type in the standard CMOS setup. Onboard Serial Port 2 Select an address and corresponding interrupt for the first and second serial ports The Choices: DPMS Initial display power management signaling. Hard disk can be read and applications can be used but booting from hard disk 2.


If AC power is lost when system is not live, system will remain powered off. Active to CMD Trcd Use this item to specify the delay from the activation of a bank to the time biotar a read or write command is accepted. Reformat the hard drive. After confirmed, please follow steps below to relief the CPU protection function.

Voltage Panel Click the Voltage button in Main Panel, the button will be highlighted and the Voltage Panel will slide out to up as the following figure. Make sure power cable is securely plugged in. If the system shutdown automatically after power on system for seconds, that means the CPU protection function has been activated.

You will need to disable this feature if you add a higher performance controller. Enabled Enables the function.