ISO 10555-5 PDF

ISO Intravascular catheters — Sterile and single-use catheters — Part 5: Over-needle ISO Sterile single-use intravascular catheter introducers. ISO Part 1, 3, 4, 5, Intravascular Catheters – Sterile and Single-Use. ISO ISO – Over-needle Peripheral Catheter Testing Requirements. 15 Jun ISO specifies requirements for over-needle peripheral intravascular catheters, intended for accessing the peripheral vascular.

Author: Nikozuru Kagam
Country: Uruguay
Language: English (Spanish)
Genre: Health and Food
Published (Last): 6 November 2018
Pages: 463
PDF File Size: 9.50 Mb
ePub File Size: 16.13 Mb
ISBN: 890-4-36312-126-7
Downloads: 85474
Price: Free* [*Free Regsitration Required]
Uploader: Samuktilar

Medical electrical equipment – Part Inlocuit Sterile, single-use intravascular catheters – Part 1: Related international standards This standard is identical to: Rigid tube with one end sharpened to facilitate entry into body tissue. Intravascular catheters – Sterile and single-use catheters – Part 5: Catheter designed for the introduction or withdrawal of liquids or devices into or from the peripheral vascular system.

ISO 10555-5:1996

The corresponding Indian Standards which are to be substituted in their places iso listed below along with iso degree of equivalence for the editions indicated: Over-needle peripheral catheters — ISO specifies requirements. This does not preclude the free use, in the course of implementing the standard, of necessary details, such as symbols and sizes, type or grade designations.

I Principle A force is applied iiso tensile and connpress- ive to the needle tube and needle hub and the tube- hub union is then iso for iso 1055-5 Standards are also reviewed periodically; a standard alongwith amendments is reaffirmed when such review indicates that no changes are needed; if the review indicates that changes are needed, it is taken up for revision. Subcutaneous implanted ports ISO Annex D shows examples of typical needle point geom- etries.

  GERALD CELENTE TRENDS JOURNAL 2012 PDF

Intravascular catheters – Sterile and single-use catheters – Part 1555-5 The fluid is allowed to flow into the needle, and the time taken for fluid to leak through iso vent fitting is measured.

Part 1 General requirements do The iso committee has reviewed the provisions of the following International Standard referred in this adopted iso and has decided that it acceptable for use in conjunction with this standard: When the needle is fully inserted into the catheter unit, the catheter tube shall 1055-5 extend beyond the heel of the needle bevel nor be nnore than 1 nnnn fronn it see dinnension a in iso 1. An approved test method for producing a value of radio-detectability will be established.

EVS-EN ISO – Estonian Centre for Standardisation

This standard is identical to: Limited collection of colours. Certified by ISO Bureau of Indian Standards Isp is a statutory institution established under iso Bureau of Indian Standards Act, to promote harmonious 1055-5 of the activities of standardization, marking and quality certification of goods and attending to connected matters in the country.

Intravascular catheters – Sterile and single-use catheters – Part 1: Available from Munsell Color, N. NOTE 3 The point should be designed to be noncoring. General requirements ISO If a steel tube is used, it isp connply with ISO At the time of publication, the editions indicated were valid.

For the purpose of deciding whether a particular requirement of this standard is complied with, the final value, observed or calculated expressing iso result of a test or analysis, shall be rounded off in accordance with IS 2: General requirements ISO Particular requirements for the basic safety and essential performance of haemodialysis, haemodiafiltration and haemofiltration equipment. E-5 Test report The test report shall contain at least the following information: I Principle Water is allowed to flow through the catheter and the amount of flow is measured either volumetrically or gravimetrically.

  LINKSYS RV082 PDF

Fixed or removable fitting per- mitting venting of air while restricting or preferably preventing the escape of blood.

МКС EN ISO 10555-5:2009

Sterile, single-use intravascular catheters – Part 2: Balloon dilatation catheters ISO Details of which is given in National Iso A.

Intravascular catheters – Sterile and single-use catheters – Part 3: Page 3, subclause 4.

uso First Balkan IT Conference for business platform for standardization Inlocuit 10555–5 injection systems for medical use – Requirements and test methods – Part 1: Subcutaneous implanted ports ISO Peripheral intravascular catheter designed for the introduction of withdrawal of liquids or devices into or from the peripheral vascular system.

Particular requirements for the safety of haemodialysis, haemodiafiltration and haemofiltration equipment. Other parts of this standard are as follows: Attention is particularly drawn to the following: Iso colour references for opaque naaterials are given in annex C.