Every time a media roll is printed, you should clean this compartment to reduce the incidence dust. After the cutter is installed, install media and ribbon. Peel-off mode peels backing material away from the label as it prints. Thermal Transfer printing requires media to print with appropriate ribbon. Such proprietary information may not be used, reproduced, or disclosed to any other parties for any other purpose without the expressed written permission of Argox Information Co. Turn off the printer.

Uploader: Mezishura
Date Added: 25 September 2009
File Size: 37.52 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 88312
Price: Free* [*Free Regsitration Required]

The default setting when shipped from Argox factory is shown as Figure 2 — the two arrows are in line with the black line.

Repeat if necessary until the cotton is clean after it is passed over the head. Make sure the LEDs are not blinking and remember to resend your files.

Rotate the control knob clockwise to increase ribbon tension; rotate it counter-clockwise to reduce ribbon tension. Press the FEED button to feed the media end through the cutter. The FEED button does not make the printer peel. Memory full Check graphics and soft fonts from host. The manual includes a guide to operate the printer as well as related information on troubleshooting, maintenance, and technical reference.

  IREZ USB LIVE 2 DRIVER

For the XVL, ignore this step.

If the test print appears as Figure A, remain the screw at the right of Ribbon Bracket fixed, then loose the screw at the left, and gradually fine-tune upward, until the print quality gets improved.

Close the peeler module using z peel-off mechanism release lever.

Argox X Industrial Label Printer.

The ribbon shaft has its user-friendly feature arvox allow users to adjust the tension of ribbon shaft by rotating the knob. Check if the printer power is turned on. Turn off the printer. It is applicable with printer models: Figure 1 Figure 2 94 Dispenser Installation Install a dispenser into the printer as follows: Load new ribbon to the printer. Turn off the printer 2.

Argox X |

If there are any items missing, please contact your local dealer. During turning the Cam of cutter, release the blade from paper and them remove the paper from the cutter.

If problem continues perform a label sensor calibration. User can reset to factory default tension by adjusting the ribbon shaft while the black line was aligned to the marked arrows.

For technical and pin-out information, please refer to the Technical Reference in this manual. Figure 4 4 Peel Lever Dispenser Module 5. Figure 2 2 Print Head Module 3. Troubleshooting Normally, if the printer is in not working properly, the “READY” LED blinks continuously, and printing and communication between the host and printer stops.

  HP COMPAQ D530 SFF DRIVER

The emulation is a printer programming language 2000g which the host can communicate with your printer.

Press and hold the FEED button while turning on the power. Programmable by command Data format: Repeat Step 1; if the printing quality has not been gradually improved after five times, counterclockwise rotate five circles back to the original position and then proceed Step 3.

Seagull Argox X-2000v PPLB Free Driver Download (Official)

Illustrations are provided to help you quickly become familiar with the printer. Centronics allows a much higher communication speed than serial. Making a Barcode Reader Form 1. Insert the media into the print head module and under the paper sensor guide.

ppbl

Now printer is in normal printing mode.