Leave printer idle to cool. If the sensitivity setting is correct, try changing the darkness adjustment. Print speed exceeds the capacity of the media. The label mark sensor is not in the correct position. Poor quality label or ribbon stock. Incorrect media sensitivity setting. Incorrect darkness control setting Incorrect media sensitivity setting Poor quality label or ribbon stock Dirty print head.

Uploader: Dugal
Date Added: 23 July 2006
File Size: 44.13 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 76772
Price: Free* [*Free Regsitration Required]

Remove media from under the label sensor. Sensor type is set incorrectly. Ribbon installed upside down.

Intermec EasyCoder PM4i Print head

Clean the self-strip roller. Adjust the darkness control.

Replace the cable if it is damaged. Incorrect label rest point setting.

Troubleshooting an Intermec Printer

Set the media switch for the type of media being used. Clean the paper path. Change the sensitivity setting to match the media type.

  ENFORA SPIDER DRIVER

Printing will resume when it has cooled. The label mark sensor is not in the correct position. Lower print speed or use media rated for the print speed being used.

Print head, platen roller or label path are dirty.

Intermec – Problems, Causes and Solutions

Check the media path. Printer has aborted and reset the print speed and image bands. Serial port is incorrectly configured. If the sensitivity setting is correct, try changing the print darkness.

Intermec EasyCoder PM4i Print head – Big Sales, Big Inventory and Same Day Shipping!

Use a higher quality label and ribbon stock. The AC power cable is damaged or disconnected. The printer is configured for self-strip media. Be sure that the ribbon is installed with the shiny side facing the print head. User a higher quality label and ribbon stock. Clean print head, platen roller and label path Adjust the bias screw.

Poor quality label or ribbon stock. Uneven print contrast density.

  CANON IR2230 PRINTER DRIVER

Adjust the label rest point. The print head is up. Incorrect darkness control setting.

Set the printer to thermal transfer or direct thermal label stock. Leave printer idle to cool. Edit the format to ensure that the text fits on the label. Media is sticking to the paper path. Media is loaded incorrectly. Incorrect media sensitivity setting.